In the present study the sorption efficiency of okra leave sorbent for As(III) and As(V) is demonstrated. Sorption reaction is pH and time dependent. The sorbent shows maximum removal of As(III) and As(V) at pH 7 and pH 6 respectively and equilibrium was achieved at 180 minutes. In isotherm study...

Sodium dodecyl sulfate sulfate modified Algerian cork powder (SDS-ACP) with interesting biosorption capacity was prepared for dye removal from aqueous media. The decolorization performance of SDS-ACP was studied using methylene blue (MB) as a model dye. Experiments were conducted in batch sysytem...

The calcined clam seashell powders were applied as adsorbent to adsorb Dibutyl phthalate (DBP), from an aqueous solution. The influence of calcination conditions including temperature and time on its adsorption capability to DBP was investigated. The shell powders calcined at 500 oC had the best...

In the present investigation, marine biomass (Posidonia Oceanica) (PO), in both its unmodified PO and basic-modified (Na-PO) forms, was studied for its possible utilisation as a cheap biosorbent for the retention of amoxicillin (AMX). Biosorption studies were carried out in a batch system and the...

In this paper, the low-cost and practical adsorption for removing methylene blue (MB) dye has been developed by using recoverable natural zeolite that was magnetized with Fe3O4. The magnetization was conducted by co-precipitation technique. The adsorbents obtained from the magnetization were...

Layered double hydroxides (LDHs) of MgM3+ (M3+=Al and Cr) were synthesized by coprecipitation method to form Mg/Al and Mg/Cr LDHs. The materials were applied as adsorbents of malachite green in aqueous solution. The physical properties of Mg/Al and Mg/Cr were analyzed using XRD, FTIR, BET and TGDTA...

An adsorbent was prepared from Mangosteen shell using sulphuric acid and sodium bicarbonate as modifiers. Bicarbonate treated mangosteen shell (BTMC) was characterized using FT- IR, SEM, EDAX and XRD data. The Freundlich adsorption isotherm model gives a good fit. The maximum adsorption capacities...

In this research, capability of adsorption of modified chitosan Nano composites with functionalized mesoporous silica which synthesized by electrospinning method in the removal of direct black ANBN dye has been studied. Silicate mesoporous were functionalized during synthesis process and then the...

The present study observed the removal of the organic content from the real effluent water produced by the oilfields. The proposed treatment process was the adsorption technique using the moringa peels as adsorbing agent. The effect of processing parameters such as adsorbent dosage, contact time and...

This study highlights the potential of steel slag, which is an industrial by-product of steel making industry as treatment media for metal-rich acid mine drainage (AMD). A series of batch adsorption studies has been done to demonstrate the effects of contact time, solution pH, initial concentration...

Abstract: Water is the main factor of movement and transport of pesticides and contamination of water by these pollutants is one of the most important challenges due to their widespread use and increased concentrations. Moreover, these compounds are on the U.S.EPA Priority Pollutant list because of...

One of the known methods for dye removing from waste water is using sorbent material for fine removal of dye .The nano- cation exchanger Sulphonated poly glycidyl methacrylate (SPGMA polymer) was used as sorbent material for removing one of the common cationic dyes. SPGMA polymer was prepared and...

In this study, the potential textile dye biosorption capacity of a low-cost biosorbent (P. animale) was tested as functions of pH, biosorbent type, initial dye concentration, temperature, contact time and biosorbent dosage at batch scale level. The optimal conditions are 2, dried biosorbent, 93.16...

Synthetic dyes have a hurtful effect on human health and the environment. In this work, activated carbon was produced from date stones for use in elimination of methylene blue charged in aqueous solutions. Before that, the adsorbent was characterized by BET method, SEM, X-ray and TGA. The results of...

In this study activated carbon is produced from areca plant leaves, an agricultural waste material. The physical and chemical structural characterisation of the prepared carbon was carried out by FTIR, TGA and XRD analysis. FTIR study showed the presence of several functional groups, such as C=O, C...

Diplocyclos Palmatus biomass activated carbon (DPAC) was used in this work to remove lead (II) ion from the synthetic wastewater. The DPAC was characterized for structural, surface morphology by SEM, functional group was analyzed by FT-IR and XRD analysis. Removal of Pb2+ was studied by batch method...

Searching for low cost, accessible, simple implementation, and environmentally friendly adsorbents has been one of the concern of researchers in recent years. Therefore, the aim of this study was to investigate the efficient phenol removal from a synthetic aqueous solution using iron-coated pumice...

The intent of this research is the investigation of the nitrate reduction from aqueous solution using biomass (pine cone (PC) and PC activated carbon (PCAC)) – supported zero valent iron nanoparticles (PC-Fe0 and PCAC-Fe0). The synthesis of these nano-bio-composites was based on the reduction of...

Methylene blue is one of the most widely used dyes in various industries such as textiles and dyeing which, due to toxicity, causes several environmental problems as well as difficulties in wastewater treatment process. Therefore, many studies have been carried out on the removal of the dye from...

In this research, the Ag2CO3-PANI composite was synthesized with a simple precipitation method and then used as an effective adsorbent for adsorption of Methylene Blue cationic dyes from aqueous solution. Characterization of the adsorbent was carried out using UV–visible diffuse reflectance...

A facile strategy toward modification of aluminium filings (AF), a waste material from aluminium manufacturing industry, into a highly efficient adsorbent was examined. AF was simply treated with thermal modification to form a cheap adsorbent for Phosphorus (P) removal from aqueous solutions. The...

Removal of Co(II) ions from aqueous solutions using chitosan-vanillin (polymer I) and chitosan-ortho-vanillin (polymer II) adsorbents has been investigated under different experimental conditions. The effect of pH, contact time, adsorbent mass, temperature, and initial concentration of studied ion...

The present study investigated the possible effect of contact time, initial nickel concentration, and adsorbent concentration on removing Ni (II) ion, which is toxic to living organisms, from the aqueous media using nano zero valent iron (nZVI) and nano zero valent iron coated powdered activated...

The removal of Lead (II) from aqueous solutions using Fagopyrum esculentum Moench (Buckwheat) and Bambusa vulgaris (common bamboo) as adsorbents was investigated. The effects of various experimental parameters such as initial concentration, contact time and pH have been studied using batch...

This study presents the evaluation of a strong base (Purolite A200) and weak base (Purolite PFA847) polymeric anion exchange resins for nitrite removal. The different parameters on the removal of NO2– were investigated in batch sorption mode. Common isotherm models; Langmuir and Freundlich, were...